Water Level Controller cum indicator system - Bangalore - automatic overhead motor controller

The Water Level Controller System is an Electronic Equipment which when electrically connected to the starter of any given Pump-set motor will control the operation of the pumpset depending upon the water level in the Source and Destination Storage Tanks.

Advanced Automatic “WATER LEVEL CONTROLLER” unit Manufactured by M.V.Instruments is a Microprocessor based Electronic Device. This system when electrically connected to an Pumpset starter, performs the following functions automatically:

• Switches ON the Pump set when Water level drops below pre-set level (i.e. T2 level) in Overhead Tank.

• Switches OFF the Pump set when Water level in Overhead Tank becomes full (i.e. T1 level).

• Switches OFF the Pump set when Water level is low in Sump/Well/Borewell (i.e. S2 level).

• Switches ON the Pump set when there is sufficient water in the Sump/ Well / Borewell (i.e. S1 level).

• Switches OFF the Pump set when there is a Dry run (i.e. when Water is not being pumped into Overhead Tank due to any reason).

• Low Voltage and High Voltage Protection for the Pump set is incorporated.

• The system has Surge Voltage/Current Protection for the Pump set.

• All these functions are automatically performed. Manual interference is absolutely not required.

• Manual operation is also possible if and when required by operating the switch in Manual Position.

Contact:
Madhu Chandra. N
Mob: 98452 25674
Om Prakash. K
Mob: 98453 79491
MV Instruments
No. 507, 3rd Cross
8th Block, Koramangala
Bangalore - 560095
email: mvi_india@yahoo.com
visit us at www.water-level-controller.com